Neighbor Count is 1, Adjacent neighbor count is 1Īdjacent with neighbor 2.2.2.2 (Designated Router) Last flood scan time is 1 msec, maximum is 1 msec Last flood scan length is 1, maximum is 1 Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5 Transmit Delay is 1 sec, State BDR, Priority 1ĭesignated Router (ID) 2.2.2.2, Interface address 1.1.1.2īackup Designated router (ID) 1.1.1.1, Interface address 1.1.1.1 Topology-MTID Cost Disabled Shutdown Topology Name Process ID 1, Router ID 1.1.1.1, Network Type BROADCAST, Cost: 1
Internet Address 1.1.1.1/30, Area 0, Attached via Network Statement GigabitEthernet0/0 is up, line protocol is up We can also use ‘show ip ospf interface ’ to verify interfaces that are actively participating in the OSPF process.
SETTING UP BACKUP CISCO SECURE ACCESS CONTROL SYSTEM 5.8.1. UPDATE
Incoming update filter list for all interfaces is not set Outgoing update filter list for all interfaces is not set It will give you information like Router ID, the number of areas, network commands, and admin distance. If you only have access to user mode, then you can verify by using the ‘show ip protocols’ command.
If you have access to the privileged mode of OSPF routers, you can use ‘show running-config’ to verify the configuration. OSPF is an open standard Interior Gateway Protocol (IGP) used for exchanging routing table information throughout a single Autonomous System (AS) in an IP network. As a network engineer, you will likely encounter OSPF issues most of the time. In this article, we are going to cover Open Shortest Path First (OSPF) configuration verification and troubleshooting.
0 kommentar(er)
